HDPE spiral carbon pipe production line
　1. HDPE spiral carbon pipe production line introduction
　Configuration polyolefin dedicated single screw extruder with a high-speed extrusion, high-speed characteristics etc.
　Separate dedicated mixing screw and spiral structure of the die head, streaming Road reasonable, pipe inside wall and outside surface smooth.
　Specially designed calibration sizing cooling method: the production of the scope of 50-200mm, the production speed up to 0.6-1.5 m/min.
　Standard design pipe die head.
　Spiral-type die head, the large space of flows, and ensuring there is enough melt residence time.
　Low melting temperature of the best design, pipe stress small, pipe inside wall and outside surface smooth.
　Highly flexible, applicable co-extrusion all polyolefin material can be extrusion two layer and three layer different specifications use of spiral carbon enhance pipe.
　Optimize the design of copper calibration sizing with the entrance pre-cooling device and powerful vacuum suction device, applicable to the high-speed pipe extrusion.
　Specially designed spray head brought about by efficient spray cooling.
　Longitudinal movement motor adjustment, both vertically and horizontally to achieve three-dimensional adjustment.
　Vacuum calibration water tanks and Spray cooling water tanks of stainless steel meterial.

　2. HDPE spiral carbon pipe production line technical parameters
Production model
Extruder
Production diameter /mm
Production speed /m
Winding machine
Total installed capacity /kw
MS-PTPG
SJ65/30
50-125mm
0.6-1.5
SQ200
70kw
MS-PTPG
SJ90/30
50-200mm
0.6-1.5
SQ200
95kw
HDPE spiral carbon pipe introduction
        

　3. HDPE spiral carbon pipe production line picture
HDPE spiral carbon pipe production line
HDPE spiral carbon pipe production line
HDPE spiral carbon pipe production line